Epoxy Adhesive 30 Minute 4 oz Kit



Epoxy Adhesive 30 Minute 4 oz Kit

Parbond 300 Epoxy Adhesive

A versatile easy to use solvent free epoxy adhesive, which can be used to bond or
repair most materials such as wood, metal, glass, ceramic, plastics and rubbers. The
product hardens in 30 minutes with high bond strength and chemical resistance.

--Easy to use two component adhesive system
--Excellent adhesion to wide variety of materials such as aluminum, copper,
steel, brass, concrete, FRP/SMC, wood, glass, plastics, ceramics, painted
metals, graphite, polyurethane, galvanized metals, rigid plastics, etc.
--High bond strength develops in 4 -6 hours.

Liquid Adhesive:
Viscosity of Part A @ 25 0C 18,000 – 20,000 cps
Viscosity of Part B @ 25 0C 16,000 – 18,000 cps
Mixed Viscosity @ 25 0C 15, 000 – 20,000 Pa.S
Mixing Ratio: 1:1 vol/vol or wt/wt
Mixed Color: Clear
Working Life: 30 minutes
Specific Gravity 1.1
Percent Solid 100
Adhesive Set-up Time: 2-3 hours.
Mechanical Properties:
Shore Hardness D 78 - 80
(ASTM D 2240)
Shear Strength (N/mm2) 18 - 24
(DIN 53283)
Peel Strength (N/mm) 3 – 5
(ISO 4578)
Thermal Conductivity (W/mK) 0.1
Coefficient of thermal expansion (1/k) 60 – 120 x 10 E-6
Dielectric Strength (kv/mm) 50 – 90
Volume resistivity (OHM/cm) 3 – 5 x 10 E 12
Service Temperature -40 0F to 250 0F

To achieve maximum performance from PARBOND 300 adhesive it is essential that
all substrates are clean, dry and free from surface contaminations such as oil or

Mix PARBOND 300 epoxy adhesive of Part A to Part B of equal amounts. Mix two
parts thoroughly for optimum performance. The epoxy can be dispensed, metered,
mixed and directly applied to the bonding surface.

After mixing PARBOND 300 adhesive should be applied directly to the surfaces to be
bonded. If an insert is to be bonded in a socket or curved, surfaces to be fixed slight
rotating of the units will eliminate any air entrapment and fully wet out both surfaces.
Edge to edge bonds should be supported. Adhesive thickness of .005 inch (5 Mil) will
provide the maximum bond strength.

Our products are generally quite harmless to handle provided that certain precautions
normally taken when handling chemicals are observed. The uncured materials must
not, for instance, be allowed to come into contact with foodstuffs or food utensils, and
measures should be taken to prevent the uncured materials from coming in contact
with the skin, since people with particularly sensitive skin may be affected. The
wearing of impervious rubber or plastic gloves will normally be necessary; likewise
the use of eye protection. The skin should be thoroughly cleansed at the end of each
working period by washing with soap and warm water. The use of solvents is to be
avoided. Disposable paper - not cloth towels - should be used to dry the skin.
Adequate ventilation of the working area is recommended. These precautions are
described in greater detail in the Material Safety Data


***NOTE: Sorry, we can NOT ship adhesives to destinations outside of the United States***